Scorpion 3032 Series Shaft
Scorpion 3032 Series Shaft
The shaft for the 3032 series motors measures 5mm in diameter, and is
88.5mm in long. The shaft kit will also fit other brushless motors that
require a 5mm shaft of this length. The shafts can be cut shorter with
a Dremel tool and a cut-off wheel if necessary to fit other motors.
Note: The shafts in the Scorpion motors are a slight press fit
into the aluminum front housing. The shafts will not just slide out
when the setscrews are removed. They need to be pressed out in a
bearing press, or in a drill press, with the front houshing of the
motor supported in a block of wood to prevent warping the front housing.
Customer feedback
Product rating
Customer Reviews
There have been no reviews for this product.
